The hot-dip galvanized Bautri system is the perfect solution for a safe and stable stand on almost all load-bearing surfaces. It consists of a head plate and three wedge-shaped foot elements and can be assembled by one person in just a few minutes.
When lying down, you fix the supports to the head plate, pull them out to the required length and mount the foot elements. The screws on the head plate are already threaded, so no additional securing is required. Then you set up the tripod. Alternatively, you can also mount short supports and only then adjust them to the required length.
The Bautri system is compatible with common building supports according to the DIN EN 1065 standard. The base elements can also be secured with chains, straps or pegs to further increase stability. The distance between the base elements is around 195 cm for a fully extended 300 cm support and around 255 cm for a 400 cm support.
You have the option of installing eyebolts and swivels of size M20. The maximum tensile load at the anchor point is 20 kN. Please note that pressure loads must be placed centrally on the head plate and a minimum support surface of 100 x 100 mm is required. The maximum pressure load must not exceed 20 kN.
The use of a fourth support or a mast as an attachment on the head plate is at your own risk. The system is not yet approved for the rescue of people.
Documents
Here you will find all important documents about our Bautri system. Everything in one place!
