Application example
Portal lift
Two Bautri tripods with a formwork beam or steel beam between them – up to 4 m high. Underneath there is room for trailers, vehicles or a pit.
Portal & Cantilever
More than a tripod: portal and cantilever arm
Conventional tripods lift vertically at a single point. From the same components, the Bautri system can also be set up as a portal or a cantilever arm – for loads above trailers, trenches, edges and floor openings. For Bautri Work and Bautri Rescue.
We know of no comparable tripod made from construction props that can also be used as a portal and a cantilever arm.
Tested
The Bautri system is DEKRA-tested for tensile and compressive loads of up to 3.3 t. This applies to the Bautri system itself – the standard configuration is the tripod.
Cantilever arm: component with verification
The KA101 adapter flange comes with a structural calculation and is available as a ready-made component set in the shop.
Portal: your responsibility
You choose and take responsibility for the beam, its fastening and the stability of the portal. We are happy to advise you beforehand.
Two configurations, one system
Component set in the shop
Cantilever arm
A beam projects beyond the head plate. The load hangs beside the tripod – over an edge or a floor opening.
In action
This is what it looks like in practice.
In developmentBeam trolley not yet approved. Never lift people with the portal lift – loads only.
In developmentTravelling with a beam trolley is not yet approved. Vertical lifting is approved.
In developmentTravelling with a beam trolley is not yet approved. Vertical lifting is approved.
Im Shop
Bauteile für Portal und Ausleger
Für einen Stahlträger mit 60 bis 100 mm Flanschbreite brauchen Sie vier Trägerklemmen Lindapter LR M12: je zwei auf jeder der beiden Kopfplatten. Das 4er-Set enthält die Klemmen samt Schrauben M12x60 und Muttern. Für den Ausleger gibt es das Adapter-Set mit Adapterflansch KA101.
Trägerklemmen Lindapter GT LR M12, galvanisch verzinkt – 4er-Set inkl. Schrauben M12x60
Portalhebung: 4 Klemmen für einen Stahlträger 60 bis 100 mm€54,95
Bautri adapter set: KA101 adapter flange + 2 Lindapter LR M12 beam clamps incl. bolt set
Ausleger: Adapterflansch KA101 mit 2 Klemmen€199,95Components, not ready-made lifting equipment
Rhönkonzept supplies the Bautri components. Assembling them into a portal or cantilever arm and using it are outside our scope of supply and the responsibility of the user. The DEKRA test refers to the Bautri system, not to the beam, its fastening or the stability of the complete set-up.
The photos and videos show application examples and are not assembly instructions.
Advice
Which configuration suits your task?
Tell us the load, span and ground – we will tell you which Bautri components you need.
Send an enquiry