Cantilever arm on the Bautri tripod
A steel beam rests on the head plate and projects beyond the tripod. At the rear, the KA101 adapter flange braces it via a prop against an abutment. The load hangs beside the tripod – over an edge or a floor opening.
A tripod that can also work as a cantilever arm. We know of no comparable tripod made from construction props that can also be used as a portal and a cantilever arm.
The Bautri system is DEKRA-tested for tensile and compressive loads of up to 3.3 t.
KA101 adapter flange, verified by calculation: 12.1 kN with centred and 7.6 kN with off-centre bolting. No load capacity in kg is guaranteed.
You as the user select, dimension and take responsibility for the beam, rear prop, abutment and the lifting device as a whole.
Lifting and lowering where no vehicle can reach.
The cantilever arm brings the anchor point to where the load actually is.
Concrete sawing and wall sawing
The hoist hangs directly above the cut – the cut-out concrete section is picked up and set down in a controlled way.
Concrete core drilling
The anchor point sits above the core hole; the heavy core is pulled out and lowered.
Floor opening
The tripod stands on the safe surface and the beam projects over the opening. Loads are lowered to the floor below or brought up from there.
Loads on the façade
Set up on a balcony, roof terrace or floor slab, the cantilever arm projects over the edge – material can be hoisted up without a vehicle having to reach the building.
Installing a debris chute
The debris chute segments are hoisted up the outside façade with the cantilever arm and moved into position – without a scaffold hoist and without a vehicle at the building.
Installation in existing buildings
Pumps, motors or units in basements and plant rooms: where there is no anchor point, a temporary one is created.
The cantilever arm in practice
What you need
The adapter set contains the KA101 adapter flange, two beam clamps and the bolt set. You choose the beam and the hoist yourself.
Bautri adapter set: KA101 adapter flange + 2 Lindapter LR M12 beam clamps incl. bolt set
KA101 adapter flange + 2 beam clamps€199,95
DELTA RED Premium 3t Spur-Gear Chain Hoist with 3m Lifting Height
Hoist – chosen by the userBACK SOON
Limits and responsibility
Component set, not lifting equipment. The adapter set is a set of components and not ready-to-use lifting equipment. Assembling and using the cantilever arm is the responsibility of the user.
- Fixed anchor point and vertical pull only – no beam trolley.
- Only the adapter flange values in kN are guaranteed, no load capacity in kg.
- Not for fall protection of persons.
- Never stand under suspended loads.
All details, data sheets and the notice on use and limitations can be found with the adapter set. The photos and videos show application examples and are not assembly instructions.
The KA101 adapter flange is available as a set.
Adapter flange, two Lindapter LR M12 beam clamps and the matching bolt set – with data sheets and calculator.
View adapter set